Process guide
LFP Battery Recycling: Black Mass, Lithium Extraction and Recovery
Follow the material basis through the process before comparing recovery percentages or costs.
Open the research labWhy the black-mass feed matters
Industrial LFP black mass is not the same material as a pure lithium iron phosphate laboratory powder. The Reyes-Martinez study examines an industrial stream after pyrolysis and mechanical processing, with copper, aluminium, graphite and electrolyte residues alongside LFP. Its findings concern that source material and experimental conditions, not every recycling feed. Read the primary study.
For your own LFP black-mass recycling study, record feed origin, preprocessing, dry mass, moisture basis and measured elemental-lithium content. Keep each measurement attached to its run or campaign. Mixing an assay from one feed with recovery from another can produce a precise-looking but unsupported result.
Follow lithium through four process questions
- Leaching: how much lithium enters the liquid, and how much remains in the residue?
- Purification: how much lithium stays in the liquid, and how much leaves with solids or wash streams?
- Concentration and precipitation: what water and energy are used, and where does lithium go in mother liquor or bleed?
- Isolated product: how much lithium is measured in the selected dry product, and what evidence supports its quality and acceptance?
This sequence is an accounting guide, not a recipe or equipment design. Your measured route may use different stages. Record only the stages and streams supported by your dataset.
Selective lithium extraction is one step
The lab can account for a sulfuric acid/hydrogen peroxide route, an oxalic acid/hydrogen peroxide route, or another researcher-described measured route. The sulfuric route has a guarded source-condition leach reconstruction. Other measured-route choices do not create predictive extraction models or borrowed performance presets.
Use your measured results for your conditions. Read the lithium recovery formula to distinguish extraction into a solution from final recovery into an isolated product.
Water and energy inputs in battery recycling
Water accounting needs consistent volumes or masses, process scope and opening/closing stocks where relevant. Separate external water demand from internal circulating water. Include wash water, evaporation and discharge when they lie inside your selected scope. Recycle flow is not automatically an equal saving in fresh-water demand.
For battery recycling energy consumption, distinguish measured utilities from a thermal estimate. A thermal estimate needs the required material amounts, temperature changes, relevant heat properties, evaporation information and efficiency assumptions. The tool does not infer plant electricity demand from a leaching temperature alone.
Do not subtract an estimated heat-recovery credit from a metered utility total that already includes that recovery. Keep hypothetical changes in a separately labelled scenario and avoid duplicate utility costs.
How literature benchmarks are used
BatteryReclaim Lab retains Reyes-Martinez et al. for source-condition leach arithmetic and Jiang et al. for additional reported lithium accounting and restricted cost arithmetic. These are separate checks, not one combined experimental recipe.
Jiang's pilot paper reports comprehensive recovery from waste LFP/C powder. The interface's audit preserves the reported basis and limitations; paper arithmetic is not a claim that its feed, circulating stocks, product qualifications or costs apply to your dataset. Read Jiang et al.'s primary paper.
The Benchmarks view displays the supported checks and source limitations. Reproducing selected numbers does not validate an entire plant, all routes or commercial performance.
Compare scenarios on the same basis
Compare feed mass, campaign length, lithium inventories, water scope and cost coverage consistently. Change an input only when you can state whether it is measured, estimated or assumed. A more favourable recovery or margin is meaningful only when the evidence and included process scope support it.
Use cost and break-even analysis to examine which supported change could alter the economic conclusion.